MBM SPRINT 3000 Bedienerhandbuch PDF herunterladen (Seite 18)

oper3500.doc Page 16 23/01/2004

10. PROBLEM SOLVING.

PROBLEM POSSIBLE CAUSES REMEDY

Motor will not start Blown Fuse Switch off and unplug machine.

Check and replace fuses as

necessary

Machine will not start

when paper is inserted

Powerful light source from

above

Shield safety cover from light or

move machine

Machine will not cycle Machine in jam mode Remove paper from machine in

stapling section to allow photo-cell to

reset

Paper jams in stapling

section

Wrong length of staple leg for

paper thickness

Use 66/6 staples for up to 15 sheets

Use 66/8 staples for over 15 sheets

Stapling head jammed Incorrect staples Switch off machine, lift safety cover,

remove staples from cassette, clear

jammed staples with tool provided.

Repeated jamming of

stapling head.

Miss aligned head with anvil Check that guide lines on stapling

head and anvil match.

Staple legs breaking. Miss aligned head with anvil Check that guide lines on stapling

head and anvil match.

One staple not on fold

line

Fold stop out of line Adjust tilt screw

Book does not travel

through machine after

stapling

Side guides too tight Open right hand side guide

Pinching around staples Residue being left on rollers Clean rollers

1 2 ... 13 14 15 16 17 18

Keine Kommentare

MBM SPRINT 3000 Bedienerhandbuch Seite 18